Static routes windows 2008 r2

By the way, I wish there was more visibility on the commands being run by Altiris. If you have an Altiris job that does the modify configuration, clear all the job history by deleting the failed operations from the Altiris console. Then ensure your jobs only apply good settings. I have made sure we specify only domain-specific settings in the modify config job, and made sure we DON'T specify anything that is 'generic' to the environment, such as default gateway.

This seems to work. Skip to main content Press Enter. Sign in. Skip auxiliary navigation Press Enter. Skip main navigation Press Enter. Toggle navigation. Search Options. Deployment Solution. Expand all Collapse all sort by most recent sort by thread. I am tring to capture and deploy windows r2 X64 enterprise on rdp 6. My client syste I'm not sure if you figured this out already or not -- but I was having a similar problem wi After deploying a Windows 7 image to exsisting computers in DS a static route is added under the ad I was seeing a bad OU n In the end, the result of your network traffic being routed to the correct network should be the same, no matter what method you choose.

With static routing, you must make an entry on your Windows Server for every network that will be routed by that server. You could configure it with two simple route add commands. On the other hand, on a network where you want the Windows Server system to route for 25 networks or to exchange routes with a Cisco network that uses RIP, you will want to choose dynamic routing.

Obviously, you do not want to have to key in those 25 networks manually nor can you provide the true dynamic features that RIP provides. Static routing in Windows Server is nothing new. We have been using the route command for years. You can configure static routing in Windows Server using either the route command or using the GUI. Thus, I highly recommend that if you are going to use static routing in Windows , you just use the route command at the windows command prompt.

Showing the static routing table is easy, just use the route print command, as you see in Figure 1 below. In the route print output, the first important thing that you see is the interface list.

Windows Server IP interfaces are labeled with an interface number. The interface numbers in Figure 1 are 16, 14, 1, 15, 20, and These interface numbers are used whenever you add or delete routes to the routing table. The second important thing in the route print output is th e IPv4 Routing Table. You can use either decimal or hexadecimal values for the interface index.

For hexadecimal values, precede the hexadecimal number with 0x. When the if parameter is omitted, the interface is determined from the gateway address. Automatic determination of the interface metric, enabled by default, determines the speed of each interface and adjusts the metrics of routes for each interface so that the fastest interface creates the routes with the lowest metric.

If the command is print or delete , the Gateway parameter can be omitted and wildcards can be used for the destination and gateway. The asterisk matches any string, and the question mark matches any single character. For example, Using an invalid combination of a destination and subnet mask netmask value displays a "Route: bad gateway address netmask" error message.

This error message appears when the destination contains one or more bits set to 1 in bit locations where the corresponding subnet mask bit is set to 0. To test this condition, express the destination and subnet mask using binary notation. The subnet mask in binary notation consists of a series of 1 bits, representing the network address portion of the destination, and a series of 0 bits, representing the host address portion of the destination.

Check to determine whether there are bits in the destination that are set to 1 for the portion of the destination that is the host address as defined by the subnet mask. This parameter is not supported by the route command for Windows 95 or Windows